Nissan Altima 2007-2012 Service Manual: BCM (Body control module)

Diagnosis Procedure

1. CHECK FUSE AND FUSIBLE LINK

Check if the following BCM fuse or fusible link are blown.

Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit.

NO >> GO TO 2

2. CHECK POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM.

3. Check voltage between BCM harness connector and ground.

Is the measurement normal? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK GROUND CIRCUIT

Check continuity between BCM harness connector and ground.

Does continuity exist? YES >> Inspection End.

NO >> Repair or replace harness.

Special Repair Requirement

1. REQUIRED WORK WHEN REPLACING BCM

Initialize control unit. Refer to BCS-6, "CONFIGURATION (BCM) : Special Repair Requirement".

>> Work End.

    Power supply and ground circuit
    ...

    IPDM E/R (Intelligent power distribution module engine room)
    Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Is the fuse blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit. NO >> GO TO 2 2. CHECK ...

    Other materials:

    Power consumption control system
    System Diagram System Description OUTLINE • BCM incorporates a power saving control function that reduces the power consumption according to the vehicle status. • BCM switches the status (control mode) by itself with the power saving control function. It performs the sleep request ...

    Readiness for inspection/maintenance (I/M) test
    Due to legal requirements in some states and Canadian Provinces, your vehicle may be required to be in what is called the “ready condition” for an Inspection/Maintenance (I/M) test of the emission control system. The vehicle is set to the “ready condition” when it is driven through c ...

    P1553 battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures ...