Nissan Altima (L32) 2007-2012 Service Manual ≻ Lan system can system (type 2) ≻ BCM branch line circuit

Nissan Altima (L32) 2007-2012 Service Manual: BCM branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of BCM.

2. Check the resistance between the BCM harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the BCM branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the BCM. Refer to BCS-42, "Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the BCM. Refer to BCS-96, "Removal and Installation".

YES (Past error)>>Error was detected in the BCM branch line.

NO >> Repair the power supply and the ground circuit.

AV branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

DLC Branch line circuit

Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors o ...

Other materials:

Rear window and outside mirror (if so equipped) defroster switch
To defrost the rear window glass and outside mirrors (if so equipped), place the ignition switch in the ON position and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to turn the defroster off. The rear window defro ...

How to park with predicted course lines
WARNING If the tires are replaced with different sized tires, the predicted course lines may be displayed incorrectly. On a snow-covered or slippery road, there may be a difference between the predicted course line and the actual course line. If the battery is disconnected or becomes disch ...

Heater operation
Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. 1. Press thebutton to the off position for normal heating. 2. Press theair flow control button. 3. Turn thefan speed control dial to the desired position. ...