Nissan Altima 2007-2012 Service Manual: BCM branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of BCM.

2. Check the resistance between the BCM harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the BCM branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the BCM. Refer to BCS-42, "Diagnosis Procedure".

Is the inspection result normal? YES (Present error)>>Replace the BCM. Refer to BCS-96, "Removal and Installation".

YES (Past error)>>Error was detected in the BCM branch line.

NO >> Repair the power supply and the ground circuit.

    AV branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    DLC branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors o ...

    Other materials:

    Power supply and ground circuit
    Diagnosis Procedure 1.INSPECTION START Start engine. Is engine running? YES >> GO TO 8. NO >> GO TO 2. 2.CHECK ECM POWER SUPPLY CIRCUIT-I 1. Turn ignition switch OFF and then ON. 2. Check the voltage between ECM harness connector and ground. Is the inspection result ...

    Front wiper and washer system
    System Diagram System Description OUTLINE The front wiper is controlled by each function of BCM and IPDM E/R. Control by BCM • Combination switch reading function • Front wiper control function Control by IPDM E/R • Front wiper control function • Relay control function FRONT WIP ...

    Center speaker
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the center speaker using the audio signal circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect BOSE speaker amp. connector B121 and cente ...