Nissan Altima 2007-2012 Service Manual: BCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair the terminal and connector.
2.CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect the connector of BCM.
2. Check the resistance between the BCM harness connector terminals.
Is the measurement value within the specification? YES >> GO TO 3.
NO >> Repair the BCM branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the BCM. Refer to BCS-42, "Diagnosis Procedure".
Is the inspection result normal? YES (Present error)>>Replace the BCM. Refer to BCS-96, "Removal and Installation".
YES (Past error)>>Error was detected in the BCM branch line.
NO >> Repair the power supply and the ground circuit.
AV Branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors ...
DLC branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors o ...
Other materials:
Rear door glass
Exploded View
1. Rear door
2. Door glass run
3. Door glass
4. Inside seal
5. Partition sash
6. Rear window seal
7. Door rear, glass
8. Regulator assembly
9. Window motor
10. Water shield
Removal and Installation
REMOVAL
1. Remove the rear door finisher. Refer to INT-34, "Remova ...
Mechanical system
Cross-Sectional View
1. Converter housing
2. Oil pump
3. Forward clutch
4. Reverse brake
5. Planetary carrier
6. Primary pulley
7. Steel belt
8. Sun gear
9. Side cover
10. Internal gear
11. Secondary pulley
12. Final gear
13. Differential case
14. Idler gear
15. Reduction gear
16. ...
Additional service when removing battery negative terminal
Description
Initial setting is necessary when battery terminal is removed.
CAUTION:
The following specified operations are not performed under the non-initialized
condition.
• Auto-up operation
• Anti-pinch function
• Retained power operation
Special Repair Requirement
INITIALIZAT ...