Nissan Altima 2007-2012 Service Manual: Blower motor
Removal and Installation
REMOVAL
1. Remove the glove box. Refer to IP-12, "Removal and Installation".
2. Disconnect the blower motor connector (1).
3. Remove the three blower motor screws (A) and remove the blower motor from the blower unit.
INSTALLATION
Installation is in the reverse order of removal.
Blower unit
Removal and Installation COMPONENTS 1. Heater and cooling unit 2. Blower unit Front REMOVAL 1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and Installation&q ...Fan control amplifier
Removal and Installation The fan control amplifier is part of the blower motor. Refer to VTL-15, "Removal and Installation". ...Other materials:
Precaution
Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front ...
Washer tank
Removal and Installation
REMOVAL
1. Remove the washer tank filler tube (1).
2. Remove engine under cover.
3. Position the RH fender protector back. For Sedan Refer to EXT-40, "Removal
and Installation". For Coupe
Refer to EXT-19, "Removal and Installation" .
4. Discon ...
Spark plug
Removal and Installation
1. Ignition coil
2. Spark plug
3. Rocker cover
REMOVAL
1. Remove the ignition coil. Refer to EM-35, "Removal and Installation".
2. Remove the spark plug with a suitable spark plug wrench.
INSPECTION AFTER REMOVAL
• Do not use a wire brush for clean ...