Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio without navigation ≻ Component diagnosis ≻ Power supply and ground circuit (sedan) ≻ Bose speaker AMP

Nissan Altima (L32) 2007-2012 Service Manual: Bose speaker AMP

Diagnosis Procedure

1.CHECK FUSE

Check for blown fuses.

Are the fuses OK? YES >> GO TO 2

NO >> Be sure to eliminate cause of malfunction before installing new fuse.

2.CHECK POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BOSE speaker amp connector.

3. Check voltage between BOSE speaker amp harness connector and ground.

Is battery voltage present? YES >> GO TO 3

NO >> Check harness between BOSE speaker amp and fuse.

3.CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BOSE speaker amp connector.

3. Check continuity between BOSE speaker amp harness connector and ground.

Does continuity exist? YES >> INSPECTION END.

NO >> Repair harness or connector.

Audio unit

Diagnosis Procedure 1.CHECK FUSES Check that the following fuses are not blown. Are the fuses OK? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction b ...

Satellite radio tuner

Diagnosis Procedure 1.CHECK FUSES Check that the following fuses are not blown. Are the fuses OK? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction be ...

Other materials:

RearView Monitor (if so equipped)
CAMERA or DISP button WARNING Failure to follow the warnings and instructions for proper use of the Rear- View Monitor system could result in serious injury or death. RearView Monitor is a convenience feature and is not a substitute for proper backing. Always turn and look out the windo ...

Steering wheel switch for audio control
Menu control switch/ OK button (back) switch (SEEK/TRACK) buttons Volume control switch SEEK/TRACK buttons For most audio sources, pushing the tuning switches for more than 1.5 seconds provides a different function than pushing for less than 1.5 seconds. AM and FM: Press theorbuttons f ...

Heater operation
Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. 1. Press thebutton to the off position for normal heating. 2. Press theair flow control button. 3. Turn thefan speed control dial to the desired position. ...