Nissan Altima 2007-2012 Service Manual: Both side headlamps (LO) are not turned on

Description

The headlamps (both sides) do not turn ON in any lighting switch setting.

Diagnosis Procedure

1.CHECK COMBINATION SWITCH

Check the combination switch. Refer to BCS-10, "System Description".

Is the combination switch normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning part.

2.CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT

1. Select "HL LO REQ" of IPDM E/R DATA MONITOR item.

2. With operating the lighting switch, check the monitor status.

Is the item status normal? YES >> GO TO 3

NO >> Replace BCM. Refer to BCS-96, "Removal and Installation" .

3.HEADLAMP (LO) CIRCUIT INSPECTION

Check the headlamp (LO) circuit. For Halogen headlamps, refer to EXL-42, "HEADLAMP (HALOGEN) : Diagnosis Procedure". For Xenon headlamps, refer to EXL-44, "HEADLAMP (XENON) : Diagnosis Procedure".

Is the headlamp (LO) circuit normal? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation" .

NO >> Repair or replace the malfunctioning part.

    Both side headlamps do not switch to high beam
    Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting. Diagnosis Procedure 1.COMBINATION SWITCH INSPECTION Check the combinati ...

    Parking, license plate and tail lamps are not turned on
    Description The parking, license plate and tail lamps do not turn ON in with any lighting switch setting. Diagnosis Procedure 1.COMBINATION SWITCH INSPECTION Check the combination switch. Refe ...

    Other materials:

    B2099 ignition relay off stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less. • Turn the ignition ...

    P0101 Maf sensor
    Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced as ...

    Secondary speed sensor
    Exploded View 1. CVT assembly 2. Shims 3. O-ring 4. Secondary Speed Sensor Removal and Installation Refer to the figure for removal and installation. CAUTION: • Do not reuse O-ring. • Apply CVT fluid to O-ring. • Insert the shims. • After installation is complete, check ...