Nissan Altima 2007-2012 Service Manual: Brake fluid

Draining

DRAINING

CAUTION:

• Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.

• Before working, disconnect connectors of ABS actuator and electric unit (control unit) or battery cable from the negative terminal.

1. Connect a vinyl tube to bleed valve.

2. Depress brake pedal, loosen bleed valve, and gradually remove brake fluid.

Refilling

CAUTION: • Refill with new brake fluid “DOT 3”.

• Never reuse drained brake fluid.

• Before working, disconnect connectors of ABS actuator and electric unit (control unit) or battery cable from the negative terminal.

1. Make sure there is no foreign material in the reservoir tank, and refill with new brake fluid.

2. Loosen bleed valve, depress brake pedal slowly to full stroke and then release it. Repeat the procedure every 2 or 3 seconds until the new brake fluid comes out, then close the bleed valve while depressing the pedal. Repeat the same work for each wheel.

3. Bleed air. Refer to BR-16, "Bleeding Brake System".

    Brake lines and cables
    Inspection • Check brake fluid lines and parking brake cables for improper attachment, leaks, chafing, abrasions, deterioration, etc. ...

    Other materials:

    NISSAN vehicle immobilizer system
    The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device o ...

     Front Brake Pad
    Inspection PAD WEAR Check pad thickness from an inspection hole on cylinder body. Check using a scale if necessary. Front Brake Rotor Inspection VISUAL Check surface of disc rotor for uneven wear, cracks, and serious damage. Replace if necessary. RUNOUT 1. Attach the disc rotor to ...

    Microphone
    Diagnosis Procedure 1.CHECK POWER SUPPLY CIRCUIT (MICROPHONE SIDE) Check voltage between microphone harness connector and ground. Is proper voltage present? YES >> GO TO 4 NO >> GO TO 2 2.CHECK POWER SUPPLY CIRCUIT (CONTINUITY) 1. Turn ignition switch OFF. 2. Disconnect Blu ...