Nissan Altima 2007-2012 Service Manual: C1716 - C1719 Transmitter pressure malfunction

Description

Air pressure data from one or more transmitters is out of range.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.ID REGISTRATION AND VEHICLE DRIVING

1. Carry out ID registration of all transmitters.

2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.

3. Check all tire pressures with CONSULT-III within 5 minutes.

Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp? YES >> Inspection End.

NO >> Refer to WT-18, "Diagnosis Procedure".

Diagnosis Procedure

MALFUNCTION CODE NO. 35, 36, 37 OR 38 (DTC C1716, C1717, C1718 OR C1719)

1.CHECK ALL TIRE PRESSURES

Check all tire pressures. Refer to WT-70, "Tire".

Are there any tires with pressure of 64 psi or more? YES >> Adjust tire pressure to specified value.

NO >> GO TO 2

2.ID REGISTRATION AND VEHICLE DRIVING

1. Carry out ID registration of all transmitters. Refer to WT-6, "ID Registration Procedure".

2. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.

3. Check all tire pressures with CONSULT-III within 15 minutes after vehicle speed becomes 17 km/h (11 MPH).

Does “DATA MONITOR ITEM” display 64 psi or more? YES >> Replace transmitter. Refer to WT-68, "Removal and Installation". GO TO 3.

NO >> GO TO 3

3.ID REGISTRATION AND VEHICLE DRIVING

1. Carry out ID registration of all transmitters.

2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.

3. Check all tire pressures with CONSULT-III within 5 minutes.

Does “DATA MONITOR ITEM” display tire pressure as normal without any warning lamp? YES >> Inspection End.

NO >> Proceed to the inspection applicable to DTC.

Special Repair Requirement

Perform preliminary check. Refer to WT-5, "Preliminary Check".

    C1712 - C1715, C1720 - C1723, C1724 -C1727 Transmitter malfunction
    Description One or more transmitters are malfunctioning internally. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DRIVE VEHICLE 1. Drive at a speed of 40 km/h (25 MPH) or more f ...

    C1729 vehicle speed signal
    Description The vehicle speed signal is not being detected by the BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULTS 1. On SELECT DIAG MODE, select t ...

    Other materials:

    Idle air volume learning
     Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps engine idle speed within the specific range. It must be performed under the following conditions: • Each time the electric throttle control actuator or ECM is replaced. • Idle speed o ...

    Engine oil
     Changing Engine Oil WARNING: • Be careful not to burn yourself, as the engine oil may be hot. • Prolonged and repeated contact with used engine oil may cause skin cancer: try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand c ...

    Front door speaker (sedan)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front door speakers using the audio signal circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect BOSE speaker amp. connector B121 and su ...