Nissan Altima 2007-2012 Service Manual: Camera image signal circuit (rear view camera to camera control unit)(coupe)
Description
Rear view camera images are transmitted to the rear view camera control unit using the camera image signal circuits.
Diagnosis Procedure
1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit connector and rear view camera connector.
3. Check continuity between rear view camera control unit harness connector B31 (A) terminals 9, 10 and rear view camera harness connector T7 (B) terminals 3, 4.
4. Check continuity between rear view camera control unit harness connector B31 (A) terminals 9, 10 and ground.
Is inspection result OK? YES >> GO TO 2
NO >> Repair harness or connector.
2.CHECK CAMERA IMAGE SIGNAL
1. Connect rear view camera control unit connector and rear view camera connector.
2. Turn ignition switch ON.
3. Check signal between rear view camera control unit harness connector B31 terminals 10 and 9.
Is inspection result OK? YES >> Replace rear view camera control unit. Refer to AV-458, "Removal and Installation - Coupe".
NO >> Replace rear view camera. Refer to AV-457, "Removal and Installation".
Microphone signal circuit
Description Power is supplied to the microphone from the AV control unit. The microphone transmits voice signals to the AV control unit. Diagnosis Procedure 1.CHECK CONTINUITY BETWEEN AV CONTRO ...Camera image signal circuit (rear view camera to camera control unit)(sedan)
Description Rear view camera images are transmitted to the rear view camera control unit using the camera image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINU ...Other materials:
Front power window switch
Description
• BCM supplies power.
• Front power window motor RH will be operated if power window and door
lock/unlock switch RH is operated.
Component Function Check
Power Window And Door Lock/unlock Switch RH
1. CHECK FRONT POWER WINDOW MOTOR RH FUNCTION
Does front power window ...
CVT fluid
RE0F09B
Inspection
CHECKING CVT FLUID
Fluid level should be checked with the fluid warmed up to 50 to 80°C (122 to
176°F). The fluid level check procedure
is as follows:
1. Check for fluid leakage.
2. With the engine warmed up, drive the vehicle in an urban area.
When ambient t ...
Cruise control operations
The cruise control allows driving at a speed between
25 - 89 MPH (40 - 144 km/h) without
keeping your foot on the accelerator pedal.
To turn on the cruise control, push the
ON·OFF switch on. The CRUISE indicator light in
the instrument panel will illuminate.
To set cruising speed, accelerat ...