Nissan Altima 2007-2012 Service Manual: Camera on signal circuit (coupe)
Description
When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera.
Diagnosis Procedure
1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit connector and rear view camera connector.
3. Check continuity between rear view camera control unit harness connector B31 (A) terminal 8 and rear view camera harness connector T7 (B) terminal 1.
4. Check continuity between rear view camera control unit harness connector B31 (B) terminal 8 and ground.
Is inspection result OK? YES >> GO TO 2
NO >> Repair harness or connector.
2.CHECK CAMERA ON SIGNAL VOLTAGE
1. Connect rear view camera control unit connector and rear view camera connector.
2. Turn ignition switch ON.
3. Check voltage between rear view camera control unit harness connector B31 terminal 8 and ground.
Is inspection result OK? YES >> Replace rear view camera. Refer to AV-457, "Removal and Installation".
NO >> Replace rear view camera control unit. Refer to AV-458, "Removal and Installation - Coupe".
Camera image signal circuit (rear view camera to camera control unit)(sedan)
Description Rear view camera images are transmitted to the rear view camera control unit using the camera image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINU ...Camera on signal circuit (sedan)
Description When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera. Diagnosis Procedure 1.CHECK CAMERA ON SIGNAL ...Other materials:
Input shaft and gear
Exploded View
Refer to TM-28, "Exploded View".
Disassembly
1. Before disassembling, measure end play for 3rd, 4th, 5th, and
6th input gears.
End play standard value : Refer to TM-83, "End Play".
2. Remove oil channel.
3. Press out input shaft rear bearing using Tool an ...
AV branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the AV control unit for damage, bend
and loose connection (unit
side and connector side).
I ...
B2560 starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the starter
relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2560 is displayed with DTC U10 ...