Nissan Altima Owners Manual: Changing engine oil filter
1. Park the vehicle on a level surface and apply the parking brake.
2. Turn the engine off.
3. Place a large drain pan under the oil filter A .
4. Loosen the oil filter A with an oil filter wrench by turning it counterclockwise. Then remove the oil filter by turning it by hand.
VQ35DE
CAUTION
Be careful not to burn yourself. The engine oil may be hot.
5. Wipe the engine oil filter sealing surface with a clean rag.
CAUTION
Be sure to remove any old gasket material remaining on the sealing surface of the engine. Failure to do so could lead to engine damage.
6. Coat the gasket on the new filter with clean engine oil.
7. Screw on the oil filter until a slight resistance is felt, then tighten an additional 2/3 turn.
8. Start the engine and check for leakage around the oil filter. Correct as required.
9. Turn the engine off and wait more than 10 minutes. Check the oil level. Add engine oil if necessary.
Changing engine oil
QR25DE engine 1. Park the vehicle on a level surface and apply the parking brake. 2. Start the engine and let it idle until it reaches operating temperature, then turn it off. 3. Remove the oil ...Continuously Variable Transmission (CVT) fluid
CAUTION ● Use only Genuine NISSAN CVT Fluid NS-3. Do not mix with other fluids. ● Using transmission fluid other than Genuine NISSAN CVT Fluid NS-3 will damage the CVT, which is not c ...Other materials:
Engine coolant temperature gauge
System Diagram
System Description
The engine coolant temperature gauge indicates the engine coolant
temperature.
The ECM provides an engine coolant temperature signal to the combination meter
via CAN communication
lines.
Component Parts Location
1. Combination meter M24
2. IPDM ...
Stall test
Inspection and Judgment
INSPECTION
1. Inspect the amount of engine oil. Replenish the engine oil if necessary.
2. Drive for about 10 minutes to warm up the vehicle so that the
CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the
amount of CVT fluid. Replenish if necessary.
3. ...
Ecu diagnosis
TCM
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
*1: This circuit is not used.
*2: A circuit tester cannot be used to test this item.
Wiring Diagram - CVT CONTROL SYSTEM -
Coupe
Wiring Diagram - CVT CONTROL SYSTEM - Sedan
...