Nissan Altima (L32) 2007-2012 Service Manual: Charging system preliminary inspection
Inspection Procedure
1.CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal? YES >> GO TO 2
NO >> Repair battery terminals connection.
2.CHECK FUSE
Check for blown fuse and fusible link.
Is the inspection result normal? YES >> GO TO 3
NO >> Be sure to eliminate cause of malfunction before installing new fuse or fusible link.
3.CHECK GENERATOR GROUND TERMINAL CONNECTION
Check if connector E230 terminal 5 (generator ground harness) is clean and tight.
Is the inspection result normal? YES >> GO TO 4
NO >> Repair connection.
4.CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to CHG-29, "Inspection".
Is the inspection result normal? YES >> Inspection End.
NO >> Repair as needed.
Power generation voltage variable control system operation inspection
Inspection Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the respons ...Other materials:
Rear regulator
Exploded View
1. Rear door
2. Door glass run
3. Door glass
4. Inside seal
5. Partition sash
6. Door rear glass seal
7. Door rear glass
8. Regulator assembly
9. Window motor
10. Water shield
Disassembly
1. Remove the power window motor screws (A).
2. Remove power window motor from re ...
U1000 Can comm circuit
Description
Refer to AV-240, "System Description".
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
Symptom: Displays “CAN COMM CIRCUIT [U1000]” as a self-diagnosis result of AV
control unit.
1.CHECK CAN COMMUNICATION
Select “SELF-DIAG RESULTS” mode for “MULTI AV” w ...
Expansion valve
Removal and Installation for Expansion Valve
REMOVAL
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Remove the strut tower bar. Refer to FSU-12, "Exploded View".
3. Remove the upper cowl. Refer to EXT-18, "Removal and Instal ...