Nissan Altima Owners Manual: Checking bulbs

With all doors closed, apply the parking brake and place the ignition switch to the ON position without starting the engine. The following lights will come on:

The following lights (if equipped) come on briefly


The following lights (if equipped) come on briefly and then go off:

If any light fails to come on, it may indicate


If any light fails to come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system repaired promptly.

    Warning lights
    For additional information on warnings and indicators, see “Vehicle information display” later in this section. Anti-lock Braking System (ABS) warning light When the ignition switch is plac ...

    Other materials:

    STRG branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side) ...

    Rocker cover
    Exploded View 1. Rocker cover (RH) 2. Rocker cover gasket (RH) 3. Rocker cover gasket (LH) 4. Rocker cover (LH) A. Follow installation procedure Removal and Installation LH REMOVAL 1. Remove the engine cover, using power tool. 2. Remove front air duct. 3. Remove blow by hose from ...

    U1208 DVD-ROM comm
    Description Refer to AV-240, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK DVD-ROM Check DVD-ROM for dirt, scratches and warpage. Is the DVD-ROM clean and undamaged? OK >> Replace AV control unit. Refer to AV-437, "Removal and Insta ...