Nissan Altima (L32) 2007-2012 Service Manual ≻ Accelerator control system Clutch ≻ On-vehicle repair ≻ Clutch pedal

Nissan Altima (L32) 2007-2012 Service Manual: Clutch pedal

Exploded View

1. Clutch pedal assembly

2. Clutch interlock switch

3. ASCD clutch switch

4. Lock nut

Removal and Installation

REMOVAL

1. Disconnect master cylinder rod end from clutch pedal lever.

2. Disconnect the ASCD clutch switch and clutch interlock switch harness connectors.

3. Remove clutch pedal assembly nuts and then remove clutch pedal assembly.

INSTALLATION

Installation is in the reverse order of removal.

• After installing the clutch switches, adjust the switch positions. Refer to CL-6, "Inspection and Adjustment".

Inspection

• After removal, check clutch pedal for bend, damage or a cracked weld. If bend, damage or a cracked weld is found, replace clutch pedal assembly.

Clutch master cylinder

Removal and Installation REMOVAL 1. Remove the air cleaner and air duct. Refer to EM-19, "Removal and Installation" for QR25DE and EM- 123, "Removal and Installation" for VQ35 ...

Other materials:

Jacking up vehicle and removing the damaged tire (2WD models)
WARNING Never get under the vehicle while it is supported only by the jack. If it is necessary to work under the vehicle, support it with safety stands. Use only the jack provided with your vehicle to lift the vehicle. Do not use the jack provided with your vehicle on other vehicles. The ja ...

Trip computer
1. Home This display indicates the home screen. 2. Vehicle speed The vehicle speed mode shows the current vehicle speed and the average vehicle speed since the last reset. Average vehicle speed: Press and hold the OK button on the steering wheel to bring up the drive computer Reset menu, and follow ...

Push-button ignition switch
WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed three consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops while ...