Nissan Altima 2007-2012 Service Manual: Combination meter

Diagnosis Procedure

1.CHECK FUSES

Check for blown combination meter fuses.

Is the inspection result normal? YES >> GO TO 2

NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.

2.POWER SUPPLY CIRCUIT CHECK

1. Disconnect combination meter connector.

2. Check voltage between combination meter harness connector M24 terminals 1, 2, 14 and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Check harness for open between combination meter and fuse.

3.GROUND CIRCUIT CHECK

1. Turn ignition switch OFF.

2. Check continuity between combination meter harness connector terminals 3, 4, 23 and ground.

Is the inspection result normal? YES >> Inspection End.

NO >> Check ground harness.

    BCM (Body control module)
    Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible li ...

    Other materials:

    P0127 IAT sensor
    Description The intake air temperature sensor is built-into mass air flow sensor (1). The sensor detects intake air temperature and transmits a signal to the ECM. The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance of the ther ...

    Remote Engine Start (if so equipped)
    The button will be on the NISSAN Intelligent Key® if the vehicle has remote engine start. This feature allows the engine to start from outside the vehicle. The following features may be affected when the remote start feature is used: ● Vehicles with a manual climate control sys ...

    Key slot illumination
    Description Blinks when Intelligent Key insertion is required. Component Function Check 1.CHECK FUNCTION Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode. Is the inspection result normal? YES >> Key slot function is OK. NO >> Refer to SEC-313, "Diagn ...