Nissan Altima 2007-2012 Service Manual: Combination switch input circuit

Diagnosis Procedure

1. CHECK INPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN

1. Turn the ignition switch OFF.

2. Disconnect the BCM and combination switch.

3. Check continuity between BCM harness connector and combination switch harness connector.

Does continuity exist? YES >> GO TO 2

NO >> Repair or replace harness.

2. CHECK INPUT 1 - 5 SYSTEM CIRCUIT FOR SHORT

Check for continuity between BCM harness connector and ground.

Does continuity exist? YES >> Repair or replace harness.

NO >> GO TO 3

3. CHECK BCM OUTPUT VOLTAGE

1. Connect the BCM.

2. Check voltage between BCM harness connector and ground.

Is the measurement normal? YES >> GO TO 4

NO >> Replace BCM. Refer to BCS-96, "Removal and Installation".

4. CHECK BCM INPUT SIGNAL

1. Connect the combination switch.

2. Turn ON any switch in the system that is malfunctioning.

3. Check voltage between BCM harness connector and ground.

Is the measurement normal when any of the switches is turned ON? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> Replace the combination switch. Refer to WW-121, "Removal and Installation".

Special Repair Requirement

1. REQUIRED WORK WHEN REPLACING BCM

Initialize control unit. Refer to BCS-6, "CONFIGURATION (BCM) : Special Repair Requirement".

>> Work End.

    Power supply and ground circuit
    Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible li ...

    Combination switch output circuit
    Diagnosis Procedure 1. CHECK OUTPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN 1. Turn the ignition switch OFF. 2. Disconnect the BCM and combination switch. 3. Check continuity between BCM harness connect ...

    Other materials:

    Combination switch reading system
    System Diagram System Description OUTLINE • BCM reads the status of the combination switch (light, turn signal, wiper and washer) and recognizes the status of each switch. • BCM is a combination of 5 output terminals (OUTPUT 1 - 5) and 5 input terminals (INPUT 1 - 5). It reads a m ...

    Precaution
    Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front ...

    How to select piston and bearing
    DESCRIPTION *For the service parts, the grade for fitting cannot be selected between a piston pin and a connecting rod. (Only 0 grade is available.) The information at the shipment from the plant is described as a reference. • The identification grade stamped on each part is the grade ...