Nissan Altima (L32) 2007-2012 Service Manual: Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2013 ID discord, immu-strg
- B2014 chain of strg-immu
- B2108 steering lock relay
- B2109 steering lock relay
- B210a steering lock condition switch
- B210b starter control relay
- B210c starter control relay
- B210D starter relay
- B210E starter relay
- B210F PNP/clutch interlock switch
- B2110 PNP/clutch interlock switch
- B2190, P1610 nats antenna AMP
- B2191, P1615 difference of key
- B2192, P1611 ID discord, immu-ECM
- B2193, P1612 chain of ecm-immu
- B2555 stop lamp
- B2556 push-button ignition switch
- B2557 vehicle speed
- B2560 starter control relay
- B2601 shift position
- B2602 shift position
- B2603 shift position status
- B2604 PNP switch
- B2605 PNP switch
- B2606 steering lock relay
- B2607 steering lock relay
- B2608 starter relay
- B2609 steering status
- B260b steering lock unit
- B260c steering lock unit
- B260d steering lock unit
- B260f engine status
- B2612 steering status
- B2617 starter relay circuit
- B2619 BCM
- B261a push-button ignition switch
- B26e1 no reception of engine status signal
Diagnosis system (BCM)
COMMON ITEM Diagnosis Description BCM CONSULT-III FUNCTION CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functio ...U1000 can comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excell ...Other materials:
B2612 steering status
Description
There are 2 switches in the electronic steering column lock. IPDM E/R
compares those 2 switches conditions
to judge the present steering status and transmit the result to BCM via CAN
communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2612 is displayed with DTC U10 ...
Control valve
Exploded View
COMPONENT PARTS LOCATION
1. Transaxle assembly
2. Control valve
3. Bracket
4. O-ring
5. Oil strainer assembly
6. Magnet
7. Oil pan bolt
8. Oil pan
9. Oil pan gasket
10. Lock nut
11. Washer
12. Manual plate
13. Collar
14. Lip seal
15. Snap ring
A. CVT unit connector
...
CVT fluid
Inspection
CHECKING CVT FLUID
Fluid level should be checked with the fluid warmed up to 50° to 80°C (122°
to 176°F). The fluid level check
procedure is as follows:
1. Check for fluid leakage.
2. With the engine warmed up, drive the vehicle in an urban area.
When ambient temperature ...