Nissan Altima 2007-2012 Service Manual: Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2013 ID discord, immu-strg
- B2014 chain of strg-immu
- B2108 steering lock relay
- B2109 steering lock relay
- B210A steering lock condition switch
- B210B starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- B210F PNP/Clutch interlock switch
- B2110 PNP/Clutch interlock switch
- B2190, P1610 nats antenna amp
- B2191, P1615 Difference of key
- B2192, P1611 ID discord, immu-ecm
- B2193, P1612 chain of ECM-IMMU
- B2555 stop lamp
- B2556 push-button ignition switch
- B2557 vehicle speed
- B2560 starter control relay
- B2601 shift position
- B2602 shift position
- B2603 shift position status
- B2604 PNP switch
- B2605 PNP switch
- B2606 steering lock relay
- B2607 steering lock relay
- B2608 starter relay
- B2609 steering status
- B260B steering lock unit
- B260C steering lock unit
- B260D steering lock unit
- B260F engine status
- B2612 steering status
- B2617 starter relay circuit
- B2619 BCM
- B261A push-button ignition switch
- B26e1 no reception of engine status signal
- Power supply and ground circuit
- IPDM E/R (Intelligent power distribution module engine room)
- Key slot
- Key slot illumination
- Key cylinder switch
- Horn
- Headlamp
- Warning lamp
- Vehicle security indicator
Diagnosis system (BCM)
COMMON ITEM
Diagnosis Description
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functi ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
applications. It is an on-vehicle multiplex
communication line with high data communication speed and excell ...
Other materials:
Front grille
Removal and Installation
1. Front grille
2. Bumper fascia
FRONT GRILLE
Removal
1. Remove the front grille clips.
2. Release the grille tabs from the front bumper fascia, then remove the front
grille.
Installation
Installation is in the reverse order of removal. ...
On-vehicle repair
IPDM E/R (INTELLIGENT POWER DISTRIBUTION
MODULE ENGINE ROOM)
Removal and Installation
REMOVAL
1. Disconnect the battery negative terminal.
2. Remove the IPDM E/R cover (1) while pressing the pawl (A) at
the rear end of the IPDM E/R cover (1).
3. Disconnect the harness connectors from the ...
Ground
Ground Distribution
MAIN HARNESS
ENGINE ROOM HARNESS
FRONT END MODULE HARNESS
ENGINE CONTROL HARNESS
BODY HARNESS
BODY NO. 2 HARNESS
HARNESS
Harness Layout
HOW TO READ HARNESS LAYOUT
The following Harness Layouts use a map style grid to help locate
connectors on the drawi ...