Nissan Altima (L33) 2013-2018 Owners Manual: Conditions the remote start will not work
The remote start will not operate if any of the following conditions are present: ● The ignition switch is placed in the ON position.
● The hood is not securely closed.
● The hazard warning lights are on.
● The I–Key Indicator Light remains
solid in the vehicle information display.
● The alarm sounds due to illegal entry into the vehicle.
● The ignition switch is pushed without an Intelligent Key in the vehicle.
● The ignition switch is pushed with an Intelligent Key in the vehicle but the brake pedal is not depressed.
● Two remote vehicle starts, or a single remote start with an extension, have already been used.
● The vehicle is not in P (Park).
● The Remote Start function has been switched to the OFF position in Vehicle Settings of the vehicle information display. For additional information, see “Vehicle information display” in the “Instruments and controls” section of this manual.
The remote engine start may display a warning or indicator in the vehicle information display. For an explanation of the warning or indicator please see “Vehicle information display warning and indicators” in the “Instruments and controls” section.
Canceling a remote start
To cancel a remote start, perform one of the following: ● Aim the Intelligent Key at the vehicle and press and hold until the parking lights turn off. ● Turn on the hazard warning ...Hood
1 Pull the hood lock release handle located below the driver’s side instrument panel; the hood springs up slightly. 2 Push the lever at the front of the hood to the side as illustrated with yo ...Other materials:
U0415 vehicle speed sig
Description
U0415 is displayed if any unusual condition is present in the reception
status of the vehicle speed signal from
the ABS actuator and electric unit (control unit).
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1. DTC CONFIRMATION
1. Erase the DTC.
2. Turn igniti ...
B2014 chain of strg-immu
Description
BCM performs the ID verification with the steering lock unit to release the
steering. BCM starts the communication
with the steering lock unit when Intelligent Key is carried into the passenger
compartment and the pushbutton
ignition switch is pressed.
DTC Logic
DTC DETECTION L ...
P1553 Battery current sensor
Description
The power generation voltage variable control enables fuel consumption to
be decreased by reducing the
engine load which is caused by the power generation of the generator. The
battery current sensor is installed
to the battery cable at the negative terminal. The sensor measures t ...