Nissan Altima 2007-2012 Service Manual: Consult-iii checking system

Description

• When CONSULT-III is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipped in the vehicle and then enable various kinds of diagnostic tests.

1 : Hood release handle

2 : Data link connector

• Refer to “CONSULT-III Operation Manual” for more information.

Function and System Application

x: Applicable

*1: With continuously variable transmission

*2: With NAVI

*3: With security card installed

CONSULT-III Data Link Connector (DLC) Circuit

INSPECTION PROCEDURE

If the CONSULT-III cannot diagnose the system properly, check the following items.

NOTE: The DDL2 circuits and CAN communication lines from DLC pins 6, 7 and 14 may be connected to more than one system. A short in a DDL circuit or CAN lines connected to a control unit in one system may affect CONSULT- III access to other systems. For a complete DDL circuit layout, refer to GI-52, "Wiring Diagram - Coupe" or GI-53, "Wiring Diagram - Sedan". For a complete CAN line layout, refer to LAN-29, "Wiring Diagram - CAN SYSTEM -".

Wiring Diagram - Coupe

Wiring Diagram - Sedan

    Service information for electrical incident
    Work Flow Control Units and Electrical Parts PRECAUTIONS • Never reverse polarity of battery terminals. • Install only parts specified for a vehicle. • Before replacing the control ...

    Engine mechanical
    ...

    Other materials:

    Vehicle security system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART OPERATION FLOW SETTING THE VEHICLE SECURITY SYSTEM Initial Condition • Ignition switch is in OFF position. Disarmed Phase • When doors or trunk is open, the vehicle security system is set in the disarmed phase on the ass ...

    Self-diagnosis function
    Diagnosis Description SELF-DIAGNOSIS SYSTEM The self-diagnosis system is built into the front air control to quickly locate the cause of malfunctions. SELF-DIAGNOSIS FUNCTION The self-diagnosis system diagnoses sensors, door motors, blower motor, etc. by system line. Refer to applicable se ...

    Front washer nozzle
     Removal and Installation REMOVAL 1. Remove the cowl top cover For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation" 2. Push washer nozzle tab (A), to release the washer nozzle (1) from the cowl top cover, then di ...