Nissan Altima Owners Manual: Control buttons

The control buttons for the Bluetooth® Hands-Free


The control buttons for the Bluetooth® Hands-Free Phone System are located on the steering wheel.

Press the  button to initiate a PHONE/SEND


Press the VR button to initiate a
VR session or answer an incoming call.

You can also use the interrupt the system feedback and button to
interrupt the system feedback and give a command at once. See “List of voice commands” and “During a call” in this section for more information.

While the Voice Recognition system is PHONE/END


While the Voice Recognition system is active, press and hold the for 5 seconds to quit the Voice button
for 5 seconds to quit the Voice Recognition system at any time.

While using the Voice Recognition ENTER button / tuning switch


While using the Voice Recognition system, tilt the tuning switch up or down to manually control the phone system. Press the ENTER button to select an option on the display screen.

    Using the system
    The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth® Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to ...

    Getting started
    The following procedures will help you get started using the Bluetooth® Hands-Free Phone System with NISSAN Voice Recognition. For additional command options, refer to “List of voice commands ...

    Other materials:

    IPDM E/R (Intelligent power distribution module engine room)
    Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Is the fuse blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit. NO >> GO TO 2 2. CHECK POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect IPDM E/R connectors. 3. Chec ...

    BCM (Body control module)
    Reference Value VALUES ON THE DIAGNOSIS TOOL Terminal Layout Physical Values 1: Sedan only 2: With LH front window anti-pinch 3: With LH and RH front window anti-pinch 4: With Intelligent Key 5: Without Intelligent Key Wiring Diagram - ENGIN ...

    On-vehicle maintenance
    IN-CABIN MICROFILTER Removal and Installation REMOVAL 1. Remove the glove box assembly. Refer to IP-12, "Removal and Installation". 2. Disengage the filter cover tab (1) to remove the filter cover. 3. Remove the in-cabin microfilter from the blower unit by using the pull tab on ...