Nissan Altima Owners Manual: Control buttons
The control buttons for the Bluetooth® Hands- Free Phone System are located on the steering wheel.
PHONE/SEND
Press the button to initiate
a VR session or answer an incoming
call.
You can also use the button
to interrupt the system feedback
and give a command at once. See
“List of voice commands” and
“During a call” in this section for
more information.
PHONE/END
While the voice recognition system
is active, press and hold
the button for 5 seconds to
quit the voice recognition system
at any time.
Tuning switch
While using the voice recognition system, tilt the tuning switch up or down to manually control the phone system.
Using the system
The NISSAN Voice Recognition system allows
hands-free operation of the Bluetooth® Phone
System.
If the vehicle is in motion, some commands may
not be available so full attention may be given to ...
Connecting procedure
NOTE:
The connecting procedure must be performed
when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.
To connect a phone to the Bl ...
Other materials:
Headlamp
Description
Headlamp lighting when theft warning system is in alarm phase.
Component Function Check
1.CHECK HEADLAMP OPERATION
Check if headlamps operate by lighting switch.
Does headlamp come on when turning switch “ON”?
YES >> Headlamp circuit is OK.
NO >> Check headlamp ...
U120C DVD-ROM mecha detect
Description
Refer to AV-240, "System Description".
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK DVD-ROM
Check DVD-ROM for dirt, scratches and warpage.
Is the DVD-ROM clean and undamaged?
YES >> Replace AV control unit. Refer to AV-437, "Removal and I ...
Auto operation does not operate
but manual operates normally
(driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the ma ...