Nissan Altima 2007-2012 Service Manual: Control cable

Exploded View

1. Control lever

2. Control device assembly

3. Control cable socket

4. Retainer grommet

5. Control cable

6. Bracket

7. Lock plate

8. Manual lever

Removal and Installation

REMOVAL

1. Shift control lever to "P".

2. Remove the air filter assembly. Refer to EM-25, "Removal and Installation".

3. Remove the control cable nut and control cable from the manual lever.

4. Remove the lock plate and the control cable from the bracket.

5. Remove the center console. Refer to IP-18, "Disassembly and Assembly".

6. Remove the bracket covering the retainer grommet.

7. Remove the retainer grommet bolts and the retainer grommet.

8. Remove the control cable from the control device assembly.

9. Remove the control cable from the vehicle.

INSTALLATION

Installation is in the reverse order of removal.

• When installing the control cable to the control device assembly, make sure that the control cable socket is fully pressed into the control device assembly, and the control cable end is fully pressed in with the ribbed surface facing upward.

• After installation is complete, adjust and check the CVT position. Refer to TM-253, "Inspection and Adjustment".

    Control device
    Exploded View 1. Control lever knob 2. Lock pin 3. Knob cover 4. Control device selector plate 5. Control device assembly Removal and Installation REMOVAL 1. Remove the center console assem ...

    Air breather hose
    Exploded View 1. Air cleaner 2. Air breather hose 3. Transaxle assembly 4. Heater pipe 5. Clip A. Paint mark Removal and Installation CAUTION: • Install air breather hose with paint ma ...

    Other materials:

    B1086 – B1089 seat belt pre-tensioner LH
    Description DTC B1086 – B1089 SEAT BELT PRE-TENSIONER LH The seat belt pre-tensioner LH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the seat belt pre-tensioner LH. PART LOCATION Refer to SRC-7, &qu ...

    On-vehicle repair
    EXHAUST SYSTEM (QR25DE) Exploded View 1. RH rear muffler bracket 2. Gasket 3. Front exhaust tube 4. Ring gasket 5. Front exhaust tube hanger 6. Center exhaust tube 7. Mounting rubber 8. Center exhaust tube hanger 9. Gasket 10. Mounting rubber 11. Rear muffler 12. LH muffler tip 13. ...

    Microphone
    Diagnosis Procedure 1.CHECK POWER SUPPLY CIRCUIT (MICROPHONE SIDE) Check voltage between microphone harness connector and ground. Is proper voltage present? YES >> GO TO 4 NO >> GO TO 2 2.CHECK POWER SUPPLY CIRCUIT (CONTINUITY) 1. Turn ignition switch OFF. 2. Disconnect Blu ...