Nissan Altima 2007-2012 Service Manual: Control cable
Exploded View
1. Control lever
2. Control device assembly
3. Control cable socket
4. Retainer grommet
5. Control cable
6. Bracket
7. Lock plate
8. Manual lever
Removal and Installation
REMOVAL
1. Shift control lever to "P".
2. Remove the air filter assembly. Refer to EM-25, "Removal and Installation".
3. Remove the control cable nut and control cable form the manual lever.
4. Remove the lock plate and the control cable from the bracket.
5. Remove the center console. Refer to IP-12, "Removal and Installation".
6. Remove the bracket covering the retainer grommet.
7. Remove the retainer grommet bolts and the retainer grommet.
8. Remove the control cable from the control device assembly.
9. Remove the control cable from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
• When installing the control cable to the control device assembly, make sure that the control cable socket is fully pressed into the control device assembly, and the control cable end is fully pressed in with the ribbed surface facing upward.
• After installation is complete, adjust and check the CVT position. Refer to TM-432, "Inspection and Adjustment".
Control device
Exploded View
1. Control lever knob
2. Lock pin
3. Knob cover
4. Control device selector plate
5. Control device assembly
Removal and Installation
REMOVAL
1. Remove the center console assemb ...
Differential side oil seal
Exploded View
1. CVT assembly
2. Differential side oil seal
Removal and Installation
REMOVAL
1. Remove drive shaft assembly. Refer to FAX-11, "Removal and
Installation (Left Side)&quo ...
Other materials:
P0182, P0183 FTT sensor
Description
The fuel tank temperature sensor is used to detect the fuel temperature
inside the fuel tank. The sensor modifies a voltage signal from
the ECM. The modified signal returns to the ECM as the fuel temperature
input. The sensor uses a thermistor which is sensitive to the
change in tem ...
Combination meter
Diagnosis Procedure
1.CHECK FUSES
Check for blown combination meter fuses.
Is the inspection result normal?
YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction before
installing new fuse.
2.POWER SUPPLY CIRCUIT CHECK
1. Disconnect combinatio ...
BSW/LDW automatic deactivation
When dirt, rain or snow cannot be removed by
the automatic washer and blower and accumulates
on the camera, making it impossible to
detect the vehicles or the lane markers, the BSW
and/or LDW system will be turned off automatically.
The BSW light (white) and/or LDW light
(white) will blink, ...