Nissan Altima 2007-2012 Service Manual: Control device

Exploded View

1. Control lever knob

2. Lock pin

3. Knob cover

4. Control device selector plate

5. Control device assembly

Removal and Installation

REMOVAL

1. Remove the center console assembly. Refer to IP-18, "Disassembly and Assembly".

2. Disconnect the control cable from the control device assembly.

3. Disconnect the CVT device harness connector from the control device assembly.

4. Remove the control device assembly bolts and the control device assembly.

INSTALLATION

Installation is in the reverse order of removal.

• When installing the control cable to the control device assembly, make sure that the control cable is fully pressed in with the ribbed surface facing upward.

• After installation is completed, adjust and check CVT position. Refer to TM-253, "Inspection and Adjustment".

    On-vehicle repair
    TRANSMISSION CONTROL MODULE Exploded View 1. TCM 2. Bracket 3. Battery Removal and Installation REMOVAL 1. Disconnect the battery negative terminal. Refer to PG-139, "Removal and I ...

    Control cable
    Exploded View 1. Control lever 2. Control device assembly 3. Control cable socket 4. Retainer grommet 5. Control cable 6. Bracket 7. Lock plate 8. Manual lever Removal and Installation RE ...

    Other materials:

    U0140 Can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...

    Control device
    Exploded View 1. Control lever knob 2. Lock pin 3. Knob cover 4. Control device selector plate 5. Control device assembly Removal and Installation REMOVAL 1. Remove the center console assembly. Refer to IP-18, "Disassembly and Assembly". 2. Disconnect the control cable from ...

    Power distribution system
    System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION • PDS (POWER DISTRIBUTION SYSTEM) is the system that BCM controls with the operation of the pushbutton ignition switch and performs the power distribution to each power circuit. This system is used instead of the mechanical ...