Nissan Altima 2007-2012 Service Manual: Control linkage

Exploded View

1. Control lever knob

2. Control lever

3. Control device assembly

4. Retainer grommet

5. Select cable

6. Shift cable

7. Lock plate

8. Cable bracket

Removal and Installation

REMOVAL

1. Shift control lever to the neutral position.

2. Remove the air filter assembly. Refer to EM-25, "Removal and Installation" (QR25DE), EM-129, "Removal and Installation" (VQ35DE).

3. Remove the shift cable from the shift lever and cable bracket.

4. Remove the select cable from the select lever and cable bracket.

5. Remove the center console. Refer to IP-18, "Disassembly and Assembly".

6. Remove the shift cable from the control device assembly.

7. Remove the select cable from the control device assembly.

8. Remove the bracket covering the retainer grommet.

9. Remove the retainer grommet bolts and retainer grommet.

10. Remove the shift cable and select cable from the vehicle.

11. Remove the control device assembly bolts and the control device assembly.

INSTALLATION

Installation is in the reverse order of removal.

• After assembly, make sure control lever automatically returns to Neutral when it is moved to 1st, 2nd, or Reverse.

• When control lever is shifted to each position, make sure there is no binding or disconnection at each connection.

Adjustment

SELECT CABLE ADJUSTMENT

1. Remove the select cable eye end (1) from the select lever (2) of the control device.

2. Slide the lock (A) on the select cable eye end (1) away from the cable end.

3. Turn the select cable eye end (1) over and push the stopper (B) to release the adjustment.

4. Install the select cable eye end (1) to the select lever (2) of the control device

5. Hold the shift lever with the gap between the reverse gate stopper and the shifter base at the specified distance (A).

6. Push the stopper (B) into the cable eye end housing (1).

7. Slide the lock (A) over the stopper (B).

8. Check for smooth gear select operation.

    Park/neutral position switch
    Removal and Installation For removal and installation of park/neutral position switch, refer to TM-28, "Exploded View". Inspection • Check continuity. ...

    Air breather hose
    Exploded View 1. Clip 2. Air cleaner case 3. Transaxle assembly 4. Clip 5. Air breather hose A. Set paint mark and clip at front side 1. Air cleaner case 2. Transaxle assembly 3. Clip ...

    Other materials:

    Bose speaker AMP
     Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the BOSE speaker amp. are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. ...

    Low-pressure pipe
    Removal and Installation for Low-Pressure Pipe QR25DE Removal 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the strut tower bar. Refer to FSU-12, "Exploded View". 3. Remove the upper cowl. Refer to EXT-18, "Removal ...

    Drive belts
     Checking Drive Belts WARNING: Inspect the drive belt only when the engine is stopped. NOTE: On vehicles not equipped with A/C, there is an idler pulley in the position for the drive belt routing. • Make sure that the stamp mark of drive belt auto-tensioner is within the usable ...