Nissan Altima 2007-2012 Service Manual: Cooling fan

Removal and Installation

1. Fan blade

2. Fan shroud and motor assembly

REMOVAL

1. Drain engine coolant from the radiator. Refer to CO-12, "Changing Engine Coolant".

CAUTION: Perform when engine is cold.

2. Remove air cleaner duct assembly. Refer to EM-25, "Removal and Installation".

3. Disconnect radiator upper hose.

4. Disconnect fan motor connectors.

5. Remove radiator cooling fan assembly.

INSTALLATION

Installation is in the reverse order of removal.

• After installation refill engine coolant and check for leaks. Refer to CO-12, "Changing Engine Coolant" and CO-11, "System Inspection".

CAUTION: Do not spill coolant in engine compartment. Use a shop cloth to absorb coolant.

• Cooling fan is controlled by ECM. For details, refer to EC-613, "System Description".

Disassembly and Assembly of Cooling Fan

1. Fan blade

2. Fan shroud

3. Fan motor

DISASSEMBLY

1. Remove fan blade nut.

2. Remove fan blade from fan motor.

3. Remove fan motor bolts and remove fan motor from fan shroud.

ASSEMBLY

Assembly is in the reverse order of disassembly.

    Radiator
    Removal and Installation 1. Radiator 2. CVT oil cooler hose (if equipped) 3. Radiator hose (upper) 4. Radiator hose (lower) 5. Cooling fan 6. Reservoir tank 7. Reservoir hose 8. Radiator fil ...

    Water pump
    Removal and Installation 1. Water pump 2. Gaskets 3. Water pump housing 4. Water pipe 5. O-ring WARNING: Never remove the radiator cap when the engine is hot. Serious burns could occur from ...

    Other materials:

    P0740 torque converter clutch solenoid valve
    Description • The torque converter clutch solenoid valve is activated by the TCM in response to signals sent from the vehicle speed and accelerator pedal position sensors. Lock-up piston operation will then be controlled. • Lock-up operation, however, is prohibited when CVT fluid tempe ...

    Oil cooler
    Removal and Installation 1. Oil filter 2. Oil cooler bolt 3. Water pipe 4. Water hose 5. Oil cooler 6. O-ring 7. Oil pan 8. Water pipe 9. Relief valve 10. Water drain plug 11. Copper gasket 12. Water connector WARNING: Be careful not to get burned, engine coolant and engine oil may ...

    Replacing
    Replace the wiper blades if they are worn. 1. Lift the wiper arm away from the windshield. 2 Push the release tab, then move the wiper blade down the wiper arm to remove. 3 Remove the wiper blade. 4. Insert the new wiper blade onto the wiper arm until it clicks into place. 5. Rotate the w ...