Nissan Altima 2007-2012 Service Manual: CVT position
Inspection and Adjustment
INSPECTION
1. Place selector lever in “P” position, and turn ignition switch ON (engine stop).
2. Make sure that selector lever can be shifted to other than “P” position when brake pedal is depressed.
Also make sure that selector lever can be shifted from “P” position only when brake pedal is depressed.
3. Move the selector lever and check for excessive effort, sticking, noise or rattle.
4. Confirm the selector lever stops at each position with the feel of engagement when it is moved through all the positions. Check that the actual position of the selector lever matches the position shown by the shift position indicator and the manual lever on the transaxle.
5. The method of operating the selector lever to individual positions correctly should be as shown.
6. When selector button is pressed in “P”, “R”, or “N” position without applying forward/backward force to selector lever, check button operation for sticking.
7. Confirm the back-up lamps illuminate only when selector lever is placed in the “R” position. Confirm the back-up lamps do not illuminate when the selector lever is pushed toward the “R” position when in the “P” or “N” position.
8. Confirm the engine can only be started with the selector lever in the “P” and “N” positions.
9. Make sure transaxle is locked completely in “P” position.
10. When selector lever is set to manual shift gate, make sure that manual mode is displayed on combination meter.
Shift selector lever to “+” and “-” sides, and check that set shift position changes.
ADJUSTMENT
CAUTION: Apply parking brake before adjustment. 1. Loosen the control cable nut.
2. Place the manual lever and the selector lever in “P” position.
3. Tighten control cable nut to specified torque.
Control cable nut: Refer to TM-433, "Exploded View".
CAUTION: Secure the manual lever when tightening control cable nut. Make sure the manual lever stays in the "P" position.
4. Check the operation of the CVT.
Road test
Description DESCRIPTION • The purpose of the test is to determine overall performance of CVT and analyze causes of problems. • The road test consists of the following three parts: 1. “Che ...Other materials:
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend
and loose connection
(unit side and connector side).
...
ASCD brake switch
Description
When the brake pedal is depressed, ASCD brake switch is turned OFF and stop
lamp switch is turned ON.
ECM detects the state of the brake pedal by this input of two kinds (ON/OFF
signal).
Refer to EC-67, "System Description" for the ASCD function.
Component Function ...
FM/AM/SAT radio with compact disc (CD) player (Type C) (if so equipped)
1. CD eject button
2. XM button*
3. Display screen
4. CD insert slot
5. SEEK button
6. SCAN button
7. CAT button
8. BACK button
9. APPS button
10.TUNE/SCROLL knob, ENTER/SETTING
button
11.Station select (1 - 6) buttons
12.RDM button
13.RPT button
14.VOL (volume) knob / button
1 ...