Nissan Altima (L32) 2007-2012 Service Manual: Diagnosis and repair workflow
Repair Work Flow
WORK FLOW
WT-5, "Preliminary Check"
WT-52, "Self-Diagnosis (With CONSULT-III)"
WT-53, "Self-Diagnosis (Without CONSULT-III)"
WT-55, "Symptom Table"
DETAILED FLOW
1.CUSTOMER INFORMATION
Interview the customer to obtain detailed information about the symptom.
>> GO TO 2
2.PRELIMINARY CHECK
Perform preliminary check. Refer to WT-5, "Preliminary Check"
>> GO TO 3
3.SELF-DIAGNOSIS
Perform SELF-DIAGNOSIS. Refer to WT-52, "Self-Diagnosis (With CONSULT-III)"
or WT-53, "Self-Diagnosis
(Without CONSULT-III)".
>> GO TO 4
4.SYMPTOM
Check for symptoms. Refer to WT-55, "Symptom Table".
>> GO TO 5
5.MALFUNCTIONING PARTS
Repair or replace the applicable parts.
>> GO TO 6
6.DRIVE TEST
1. Perform a drive test.
2. Check the low tire pressure warning lamp.
>> GO TO 7
7.SELF-DIAGNOSIS
Perform SELF-DIAGNOSIS. Refer to WT-52, "Self-Diagnosis (With CONSULT-III)"
or WT-53, "Self-Diagnosis
(Without CONSULT-III)".
Are any DTC's displayed?
YES >> GO TO 5
NO >> Inspection End
Preliminary Check
1.TIRE PRESSURE
Check all tire pressures. Refer to WT-70, "Tire".
Do tire pressures match specification?
YES >> GO TO 2
NO >> Adjust tire pressure to spe ...
Other materials: Front manual seat adjustment
(if so equipped)
Your vehicle seats can be adjusted manually.
For additional information about adjusting
the seats, refer to the steps outlined
in this section.
WARNING
Before driving the vehicle, return the
seatback to an upright seating position
after manually releasing it. Also, make
sure the seat is locked in p ...
Rear-facing child restraint installation
using LATCH
For additional information, see all Warnings
and Cautions in the "Child safety"
and "Child restraints" before installing
a child restraint.
Do not use the lower anchors if the combined
weight of the child and the child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and the ...
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...