Nissan Altima 2007-2012 Service Manual: Diagnosis system (BCM)

COMMON ITEM

Diagnosis Description

BCM CONSULT-III FUNCTION

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE: It can perform the diagnosis modes except the following for all sub system selection items.

CONSULT-III Function

ECU IDENTIFICATION

Displays the BCM part No.

SELF-DIAG RESULT

Refer to BCS-91, "DTC Index".

MULTI REMOTE ENT

CONSULT-III Function (BCM - MULTIREMOTE ENT)

DATA MONITOR

ACTIVE TEST

WORK SUPPORT

THEFT ALM

CONSULT-III Function (BCM - THEFT ALM)

WORK SUPPORT

DATA MONITOR

ACTIVE TEST

IMMU

CONSULT-III Function (BCM - IMMU)

DATA MONITOR

ACTIVE TEST

    Vehicle security system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART OPERATION FLOW SETTING THE VEHICLE SECURITY SYSTEM Initial Condition • Ignition switch is in OFF position. Disarmed Phase ...

    Other materials:

    Washing
    Wash dirt off with a wet sponge and plenty of water. Clean the vehicle thoroughly using a mild soap, a special vehicle soap or general purpose dishwashing liquid mixed with clean, lukewarm (never hot) water. CAUTION ● Do not use car washes that use acid in the detergent. Some car washes ...

    TCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harnes ...

    Diagnosis and repair workflow
    Work Flow INTRODUCTION The TCM receives a signal from the vehicle speed sensor, PNP switch and provides shift control or lock-up control via CVT solenoid valves. The TCM also communicates with the ECM by means of a signal sent from sensing elements used with the OBD-related parts of the C ...