Nissan Altima 2007-2012 Service Manual: Diagnosis system (ECM)

CONSULT-III Function

CONSULT-III APPLICATION ITEMS

CONSULT-III can display each diagnosis item using the diagnosis test modes shown following.

DATA MONITOR

Display Item List

    Automatic air conditioner system
    System Diagram CONTROL SYSTEM The control system consists of input sensors, switches, front air control and outputs. The relationship of these components is shown in the figure below: System ...

    Self-diagnosis function
    Diagnosis Description SELF-DIAGNOSIS SYSTEM The self-diagnosis system is built into the front air control to quickly locate the cause of malfunctions. SELF-DIAGNOSIS FUNCTION The self-diagnosis ...

    Other materials:

    P0102, P0103 maf sensor
    Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced a ...

    P0145 HO2S3
    Description The heated oxygen sensor 3, after HC adsorption catalyst (Under floor), monitors the oxygen level in the exhaust gas on each bank. This sensor is made of ceramic zirconia. The zirconia generates voltage from approximately 1V in richer conditions to 0V in leaner conditions. Unde ...

    Compressor
    Removal and Installation for Compressor - QR25DE Models REMOVAL 1. Discharge the refrigerant. Refer to HA-24, "HFC-134a (R-134a) Service Procedure". 2. Remove the drive belt. Refer to EM-16, "Removal and Installation". 3. Remove the engine undercover. 4. Remove th ...