Nissan Altima 2007-2012 Service Manual: Diagnosis system (TCM)

CONSULT-III Function (TRANSMISSION)

CONSULT-III can display each diagnostic item using the diagnostic test modes shown below

FUNCTION

WORK SUPPORT MODE

Display Item List

Engine Brake Adjustment

CAUTION: Mode of “+1”“0”“−1”“−2”“OFF” can be selected by pressing the “UP”“DOWN” on CONSULT-III screen.

However, do not select mode other than “0” and “OFF”. If the “+1” or “−1” or “–2” is selected, that might cause the irregular driveability.

Check CVT Fluid Deterioration Date

CAUTION: Touch “CLEAR” after changing CVT fluid, and then erase “CVTF DETERIORATION DATE”.

SELF-DIAGNOSTIC RESULT MODE

After performing self-diagnosis, place check marks for results on the TM-264, "Diagnostic Work Sheet". Reference pages are provided following the items.

Display Items List

Refer to TM-399, "DTC Index".

DATA MONITOR MODE

Display Items List

Diagnostic Tool Function

OBD-II SELF-DIAGNOSTIC PROCEDURE (WITH GST)

Refer to EC-134, "Diagnosis Tool Function" (for California), EC-663, "Diagnosis Tool Function" (except for California)

    On board diagnostic (OBD) System
    Diagnosis Description DESCRIPTION The CVT system has two self-diagnostic systems. The first is the emission-related on board diagnostic system (OBD-II) performed by the TCM in combination wit ...

    Component diagnosis
    ...

    Other materials:

    Function information
    Component Part Location ENGINE COMPARTMENT 1. A/C compressor F3 2. Ambient sensor E211 3. Refrigerant pressure sensor E219 4. A/C relay (internal to IPDM E/R) 1. A/C compressor F3 2. Ambient sensor E211 3. Refrigerant pressure sensor E219 4. A/C relay (internal to IPDM E/R) PASSENGER ...

    Programming HomeLink® for Canadian customers and gate openers
    Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission – which may not be long enough for HomeLink® to pick up the signal during training. Similar to this Canadian law, some U.S. gate operators are designed to “timeout” ...

    C1708 - c1711 data from transmitter not being received
    Description Tire pressure data for one or more transmitters is not being received by the BCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.ID REGISTRATION AND VEHICLE DRIVING 1. Carry out ID registration of all transmitters. 2. Drive at a speed of 40 km/h (25 MPH) or more ...