Nissan Altima 2007-2012 Service Manual: Disassembly and assembly

CENTER CONSOLE ASSEMBLY

Exploded View

1. M/T finisher

2. CVT finisher

3. Storage bin (if equipped)

4. CD changer console bracket (if equipped)

5. CD changer bracket LH (if equipped)

6. CD changer bracket RH (if equipped)

7. CD changer finisher (if equipped)

8. Console

9. Console screw cover (LH)

10. Console floor bracket

11. Console rear finisher (with rear duct)

12. Console rear finisher (without rear duct)

13. Console lid assembly bracket

14. Console lid assembly

15. Cup holder CVT

16. Cup holder M/T

Disassembly and Assembly

DISASSEMBLY

1. Remove the console assembly. Refer to IP-12, "Removal and Installation".

2. Remove the cup holder screws and then remove the cup holder assembly.

3. Remove the console lid screws and remove the console lid.

4. Remove the console rear finisher.

5. Remove the console lid assembly bracket.

6. Remove the power socket from the console. Refer to PWO-5, "Removal and Installation".

ASSEMBLY

Assembly is in the reverse order of disassembly.

    On-vehicle repair
    INSTRUMENT PANEL ASSEMBLY Exploded View 1. Center speaker grille 2. Tweeter speaker grille (LH) 3. Instrument panel 4. Instrument side mask (LH) 5. Combination meter 6. Lower knee protector ...

    Other materials:

    BSW system operation
    The BSW system operates above approximately 20 MPH (32 km/h). When the camera unit detects vehicles in the detection zone, the Blind spot indicator light located inside the outside mirrors will illuminate. If the turn signal is then activated, the system chimes (twice) and the Blind spot i ...

    Subwoofer (coupe)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the subwoofers using the audio signal circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect BOSE speaker amp. connector B122 and suspect re ...

    Engine coolant
    Changing Engine Coolant WARNING: • To avoid being scalded, never change the coolant when the engine is hot. • Wrap a thick cloth around cap and carefully remove the cap. First, turn the cap a quarter of a turn to release built-up pressure. Then push down and turn the cap all the way to ...