Nissan Altima 2007-2012 Service Manual: Disassembly and assembly

Cylinder head
Removal and Installation 1. Cylinder head 2. Cylinder head gasket 3. Cylinder head bolt A. Follow installation procedure REMOVAL 1. Remove the engine and transaxle assembly. Refer to EM-72, ...

Cylinder block
Disassembly and Assembly 1. Cylinder block 2. O-ring 3. Crankshaft position sensor (POS) 4. Knock sensor 5. Cylinder block heater (if equipped) 6. Lower cylinder block 7. Lower cylinder bloc ...

Other materials:

Moving Object Detection (MOD) (if so equipped)
The Moving Object Detection (MOD) system can inform the driver of moving objects behind the vehicle when backing out of garages, maneuvering in parking lots and in other such instances. The MOD system detects moving objects by using image processing technology on the image shown in the displ ...

P0506 ISC System
Description The ECM controls the engine idle speed to a specified level via the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine idli ...

Water control valve
Removal and Installation 1. Thermostat 2. O-ring 3. Engine coolant inlet 4. Water control valve 5. Gasket 6. Engine coolant outlet 7. Copper washer 8. Engine coolant temperature sensor 9. Heater pipe A. To electric throttle control B. To oil cooler C. To heater D. To heater E. To ele ...