Nissan Altima 2007-2012 Service Manual: DLC branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

Check the resistance between the data link connector terminals.

Is the measurement value within the specification? YES (Present error)>>Check CAN system type decision again.

YES (Past error)>>Error was detected in the data link connector branch line circuit.

NO >> Repair the data link connector branch line.

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Other materials:

    Oil filter
    Removal and Installation REMOVAL 1. Remove the oil filter using Tool. Tool number : KV10115801 (J-38956) WARNING: • Be careful not to get burned, the engine and engine oil may be hot. CAUTION: • When removing, prepare a shop cloth to absorb any oil leakage or spillage. • Do not all ...

    Power steering fluid
    Check the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 0 to 30ºC (32 to 86ºF). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid ...

    Road wheel tire assembly
    Adjustment WHEEL BALANCE 1. Remove inner and outer balance weights from the wheel. CAUTION: • Be careful not to scratch the wheel during removal procedures. 2. Using releasing agent, remove double-faced adhesive tape from the wheel. CAUTION: • Be careful not to scratch the wheel durin ...