Nissan Altima (L32) 2007-2012 Service Manual: Does not operate by key cylinder
switch
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK DOOR LOCK ASSEMBLY LH (KEY CYLINDER SWITCH)
Check door lock assembly LH (key cylinder switch).
Refer to PWC-214, "Component Function Check".
Is the inspection result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK DOOR SWITCH
Check door switch.
Refer to PWC-212, "Component Function Check".
Is the inspection result normal?
YES >> Inspection End.
NO >&g ...
Diagnosis Procedure
1. CHECK INTELLIGENT KEY FUNCTION
Check Intelligent Key function.
Refer to SEC-16, "System Description".
Is the inspection result normal?
YES >> Check inte ...
Other materials: Tire labeling
Example
Federal law requires tire manufacturers
to place standardized information
on the sidewall of all tires.
This information identifies and describes
the fundamental characteristics
of the tire and also provides the
Tire Identification Number (TIN) for
safety standard certification. The TIN
ca ...
LDW system limitations
WARNING
Listed below are the system limitations
for the LDW system. Failure to follow
the warnings and instructions for
proper use of the LDW system could result
in serious injury or death.
The system will not operate at
speeds below approximately 37 mph
(60 km/h) or if it cannot detect lane
ma ...
Settings
The setting mode allows you to change the
information displayed in the vehicle information
display. It also allows you to change
vehicle functions:
VDC
Driver Assistance
Clock
Meter Settings
Vehicle Settings
Maintenance
Alarm
Tire Pressures
Unit
Language
Factory Reset
VDC
The VDC Settin ...