Nissan Altima (L32) 2007-2012 Service Manual: Door outside molding
Removal and Installation
1. Front door outside molding
2. Front door
Door Outside Molding
Removal
1. Open the front door window fully.
2. Remove the side view mirror. Refer to MIR-19, "Removal and Installation".
3. Lift and twist front door molding from rear end, disconnect clips from flange
and pull the front door molding
out backward.
Installation
Installation is in the reverse order of removal.
Removal and Installation
1. Center mudguard
A. C205 push pin
B. Splash guard screw
REMOVAL
1. Remove the C205 push-pins located on the under body.
2. Remove splash guard screws.
3. Remov ...
Removal and Installation
1. Body side outer panel
2. Windshield
3. Roof
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding from th ...
Other materials: Traffic Sign Recognition (TSR) (if so equipped)
The TSR system provides the driver with
information about the most recently detected
speed limit. The system captures
the road sign information with the multi-sensing
front camera unit A located on
the windshield in front of the inside rearview
mirror and displays the detected
signs in the vehicle ...
USB (Universal Serial Bus) Connection
Port
Type-A.
Connecting a device to the USB
Connection Port
WARNING
Do not connect, disconnect, or operate
the USB device while driving. Doing so
can be a distraction. If distracted you
could lose control of your vehicle and
cause an accident or serious injury.
CAUTION
To avoid damage and loss of f ...
Vehicle information display warnings
and indicators
The following messages may appear in
your vehicle information display.
Place the key near the start
switch
This indicator appears when the battery of
the Intelligent Key is low and when the Intelligent
Key system and the vehicle are not
communicating normally.
If this appears, touch the ignition s ...
Mudguard
Roof side molding