Nissan Altima (L32) 2007-2012 Service Manual ≻ Exterior sedan ≻ On-vehicle repair ≻ Door outside molding

Nissan Altima (L32) 2007-2012 Service Manual: Door outside molding

Removal and Installation

1. Front door outside molding

2. Rear door outside molding

Front Door Outside Molding

Removal

1. Open the front door window fully.

2. Remove the side view mirror. Refer to MIR-19, "Removal and Installation".

3. Lift and twist from rear side, disconnect clips from flange and pull the front door molding out backwards.

Installation

Installation is in the reverse order of removal.

Rear Door Outside Molding

Removal

1. Open the rear door window fully.

2. Lift and twist from rear side, then disconnect clips from flange and pull the rear door molding out.

Installation

Installation is in the reverse order of removal.

Side guard molding

Removal and Installation 1. Double-faced adhesive tape Removal CAUTION: Never apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints. • Original side g ...

Drip molding

Removal and Installation REMOVAL 1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward. 2. Remove the drip moldings. INSTALLATION Ins ...

Other materials:

Manual operation
Fan speed control buttons Press the fan speed control buttons to manually control the fan speed. Press the AUTO button to return to automatic control of the fan speed. Temperature control dial The temperature control dial allows you to adjust the temperature of the outlet air. To lower the tempera ...

Bluetooth Hands-Free Phone System
WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. If you are unable to devote full attention to vehicle operation while talking on the phon ...

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop o ...