Nissan Altima 2007-2012 Service Manual: Door speaker (coupe)

Description

The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the door speakers using the audio signal circuits.

Diagnosis Procedure

1.HARNESS CHECK

1. Disconnect BOSE speaker amp. connector B121 and suspect speaker connector.

2. Check continuity between BOSE speaker amp. harness connector B121 (A) and suspect speaker harness connector (B).

3. Check continuity between BOSE speaker amp. harness connector B121 (A) and ground.

Are continuity test results as specified? YES >> GO TO 2

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

2.DOOR SPEAKER SIGNAL CHECK

1. Connect BOSE speaker amp. connector B121 and suspect speaker connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between BOSE speaker amp. harness connector B121 terminals with CONSULT-III or oscilloscope.

Is audio signal voltage as specified? YES >> Replace suspect speaker. Refer to AV-219, "Removal and Installation".

NO >> GO TO 3

3.HARNESS CHECK

1. Disconnect audio unit connector M43 and BOSE speaker amp.

connector B121.

2. Check continuity between audio unit harness connector M43 (A) and BOSE speaker amp. harness connector B121 (B).

3. Check continuity between audio unit harness connector M43 (A) and ground.

Are continuity test results as specified? YES >> GO TO 4

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

4.DOOR SPEAKER SIGNAL CHECK

1. Connect audio unit connector and BOSE speaker amp. connector.

2. Turn ignition switch ACC.

3. Push “POWER” switch.

4. Check the signal between audio unit harness connector terminals with CONSULT-III or oscilloscope.

Are the audio signal voltage readings as specified? YES >> Replace BOSE speaker amp. Refer to AV-216, "Removal and Installation - Coupe".

NO >> Replace audio unit. Refer to AV-215, "Removal and Installation".

    Microphone
    Diagnosis Procedure 1.CHECK POWER SUPPLY CIRCUIT (MICROPHONE SIDE) Check voltage between microphone harness connector and ground. Is proper voltage present? YES >> GO TO 4 NO >> G ...

    Front door speaker (sedan)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front door speakers using the audio signal ci ...

    Other materials:

    B terminal circuit
    Description The “B” terminal is constantly supplied with battery power. Diagnosis Procedure CAUTION: Perform diagnosis under the condition that the engine cannot start by the following procedure. 1. Remove fuel pump fuse. 2. Crank or start the engine (where possible) until the fuel p ...

    Front timing chain case
    Removal and Installation 1. Gasket 2. IVT control valve cover RH 3. IVT valve RH 4. IVT valve LH 5. Water pump cover 6. IVT control valve cover LH 7. Crankshaft pulley 8. Front oil seal 9. Front timing chain case A. Follow installation procedure NOTE: • This section describes procedu ...

    P1701 transmission control module (power supply)
    Description When the power supply to the TCM is cut OFF, for example because the battery is removed, and the self-diagnosis memory function stops, malfunction is detected. NOTE: Since “P1701 TCM-POWER SUPPLY” will be indicated when replacing TCM, perform diagnosis after erasing “SE ...