Nissan Altima 2007-2012 Service Manual: Door switch

Description

Detects door open/close condition and transmits the signal to BCM.

Component Function Check

1. CHECK DOOR SWITCH INPUT SIGNAL

Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with CONSULT-III. Refer to BCS- 34, "RETAINED PWR : CONSULT-III Function (BCM - RETAINED PWR)".

Is the inspection result normal? YES >> Door switch circuit is OK.

NO >> Refer to PWC-32, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK HARNESS CONTINUITY

Check voltage between BCM connector and ground.

Is the measurement value within the specification? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> GO TO 2

2. CHECK HARNESS CONTINUITY

1. Turn ignition switch OFF.

2. Disconnect BCM and door switch.

3. Check continuity between BCM connector (A) and door switch connector (B).

4. Check continuity between BCM connector (A) and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK BCM OUTPUT SIGNAL

1. Connect BCM connector.

2. Check voltage between BCM connector and ground.

Is the measurement value within the specification? YES >> GO TO 4

NO >> Replace BCM. Refer to BCS-96, "Removal and Installation".

4. CHECK DOOR SWITCH

Check front door switch.

Refer to PWC-33, "Component Inspection".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Replace door switch.

Component Inspection

1. CHECK DOOR SWITCH

Check front door switches.

Is the inspection result normal? YES >> Door switch is OK.

NO >> Replace door switch.

    Encoder
    DRIVER SIDE Description Detects condition of the power window motor LH operation and transmits to main power window and door lock/unlock switch as pulse signal. Component Function Check 1. CH ...

    Power window lock switch
    Description Ground circuit of main power window and door lock/unlock switch shuts off if power window lock switch of main power window and door lock/unlock switch is operated. This inhibits all ...

    Other materials:

    B210C starter control relay
    Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U10 ...

    P0101 maf sensor
    Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced a ...

    B2618 BCM
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2618 is displayed with DTC U1000, first perform the trouble ...