Nissan Altima (L32) 2007-2012 Service Manual: Door switch
Description
Detects door open/close condition and transmits the signal to BCM.
Component Function Check
1. CHECK DOOR SWITCH INPUT SIGNAL
Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with CONSULT-III. Refer to BCS- 34, "RETAINED PWR : CONSULT-III Function (BCM - RETAINED PWR)".
Is the inspection result normal? YES >> Door switch circuit is OK.
NO >> Refer to PWC-212, "Diagnosis Procedure".
Diagnosis Procedure
1. CHECK HARNESS CONTINUITY
Check voltage between BCM connector and ground.
Is the measurement value within the specification? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> GO TO 2
2. CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect BCM and door switch.
3. Check continuity between BCM connector (A) and door switch connector (B).
4. Check continuity between BCM connector (A) and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK BCM OUTPUT SIGNAL
1. Connect BCM connector.
2. Check voltage between BCM connector and ground.
Is the measurement value within the specification? YES >> GO TO 4
NO >> Replace BCM. Refer to BCS-96, "Removal and Installation".
4. CHECK DOOR SWITCH
Check door switch.
Refer to PWC-213, "Component Inspection".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace door switch.
Component Inspection
1. CHECK DOOR SWITCH
Check door switches.
Is the inspection result normal? YES >> Door switch is OK.
NO >> Replace door switch.
Passenger side
Description Detects condition of the power window motor RH operation and transmits to power window and door lock/ unlock switch RH as pulse signal. Component Function Check 1. CHECK ENCOD ...Door key cylinder switch
Description Main power window and door lock/unlock switch detects condition of the door key cylinder and transmits to BCM as the LOCK or UNLOCK signals. Component Function Check 1. CHECK DOOR K ...Other materials:
P0744 a/t tcc s/v function (lock -up)
Description
This malfunction is detected when the torque converter clutch does not
lock-up as instructed by the TCM. This
is not only caused by electrical malfunction (circuits open or shorted), but
also by mechanical malfunction such
as control valve sticking, improper solenoid valve operat ...
Headlights
Replacing the xenon headlight bulb (if
so equipped)
WARNING
HIGH VOLTAGE
When xenon headlights are on, they produce
a high voltage. To prevent an electric
shock, never attempt to modify or disassemble.
Always have your xenon headlights
replaced at a NISSAN dealer. For
additional informati ...
Communication signal circuit (sedan) satellite radio tuner
Description
Communication signals are exchanged between the audio unit and satellite
radio tuner using the communication
circuits.
Diagnosis Procedure
1.CHECK HARNESS - 1
1. Turn ignition switch OFF.
2. Disconnect satellite radio tuner (factory installed) connector
B123 and au ...