Nissan Altima 2007-2012 Service Manual: Drip molding
Removal and Installation
REMOVAL
1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward.
2. Remove the drip moldings.
INSTALLATION
Installation is in the reverse order of removal.
• Insert drip moldings onto vehicle starting at the rear, working forward.
Door outside molding
Removal and Installation
1. Front door outside molding
2. Rear door outside molding
Front Door Outside Molding
Removal
1. Open the front door window fully.
2. Remove the side view mirror. ...
Roof side molding
Removal and Installation
1. Body side outer panel
2. Windshield
2. Windshield
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding ...
Other materials:
Ambient sensor
Description
COMPONENT DESCRIPTION
Ambient Sensor
The ambient sensor (1) is attached on the front bumper reinforcement.
It detects ambient temperature and converts it into a resistance
value which is then input into the front air control.
AMBIENT TEMPERATURE INPUT PROCESS
The automatic am ...
Parking brake switch signal circuit
Description
Transmits the parking brake switch signal to the combination meter.
Component Function Check
1.COMBINATION METER INPUT SIGNAL
1. Select “METER/M&A” on CONSULT-III.
2. Monitor “PKB SW” of “DATA MONITOR” while applying and releasing the parking
brake.
>> ...
Front lower link
Removal and Installation
Removal
1. Remove the front lower link nut and bolt from the knuckle side
and the adjusting bolt and nut from the suspension member side
using power tools.
• Do not reuse the adjusting nut, use a new adjusting nut for
installation.
2. Remove the front lower link ...