Nissan Altima 2007-2012 Service Manual: Driver side
Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch.
Component Function Check
1. CHECK POWER WINDOW MOTOR CIRCUIT
Does power window motor LH operate with operating main power window and door lock/unlock switch? Is the inspection result normal? YES >> Power window motor LH is OK.
NO >> Refer to PWC-202, "DRIVER SIDE : Diagnosis Procedure".
Diagnosis Procedure
Power Window Motor LH Circuit Check
1. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH OUTPUT SIGNAL
1. Disconnect power window motor LH.
2. Turn ignition switch ON.
3. Check voltage between power window motor LH connector and ground.
Is the measurement value within the specification? YES >> GO TO 2
NO >> Replace main power window and door lock/unlock switch. Refer to PWC-291, "Removal and Installation". After that, refer to PWC-199, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
2. CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch and power window motor LH.
3. Check continuity between main power window and door lock/ unlock switch connector (A) and power window motor connector LH (B).
4. Check continuity between main power window and door lock/unlock switch connector (A) and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK POWER WINDOW MOTOR
Check power window motor LH.
Refer to PWC-203, "DRIVER SIDE : Component Inspection".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace power window motor LH. Refer to GW-19, "Removal and Installation". After that, refer to PWC-203, "DRIVER SIDE : Special Repair Requirement".
Component Inspection
COMPONENT INSPECTION
1. CHECK POWER WINDOW MOTOR LH
Does motor operate by connecting the battery voltage directly to power window motor?
Is the inspection result normal? YES >> Power window motor LH is OK.
NO >> Replace power window motor LH. Refer to GW-19, "Removal and Installation". After that, refer to PWC-203, "DRIVER SIDE : Special Repair Requirement".
Special Repair Requirement
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".
Is the inspection result normal? YES >> GO TO 2
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
2. CHECK ANTI-PINCH OPERATION
Check anti-pinch operation.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".
Is the inspection result normal? YES >> Inspection End.
NO >> Refer to PWC-206, "DRIVER SIDE : Component Function Check".
Passenger side
Description
Door glass moves UP/DOWN by receiving the signal from main power window and
door lock/unlock switch or
power window and door lock/unlock switch RH.
Component Function Check
1. ...
Other materials:
Diagnosis system (BCM)
COMMON ITEM
Diagnosis Description
CONSULT-III performs the following functions via CAN communication with
BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system
selection items.
...
Sound signal circuit (coupe)
SATELLITE RADIO TUNER
Description
Left and right channel audio signals are supplied from the satellite radio
tuner to the audio unit through the
sound signal circuits.
Diagnosis Procedure
LEFT CHANNEL
1.CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect satellite radio tuner (fact ...
Air conditioner system refrigerant and oil recommendations
The air conditioner system in your NISSAN
vehicle must be charged with the refrigerant
HFC-134a (R-134a) and NISSAN A/C
system oil Type S or the exact equivalents.
CAUTION
The use of any other refrigerant or oil will
cause severe damage to the air conditioning
system and will require the repl ...