Nissan Altima 2007-2012 Service Manual: ECM branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

- ECM

- Harness connector E30

- Harness connector M1

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of ECM.

2. Check the resistance between the ECM harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the ECM branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the ECM. Refer to the following.

• QR engine models for California: EC-144, "Diagnosis Procedure" • QR engine models expect for California: EC-673, "Diagnosis Procedure" • VQ engine models: EC-1175, "Diagnosis Procedure" Is the inspection result normal? YES (Present error)>>Replace the ECM. Refer to the following.

• QR engine models for California: EC-27, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" • QR engine models except for California: EC-563, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" • VQ engine models: EC-1051, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" YES (Past error)>>Error was detected in the ECM branch line.

NO >> Repair the power supply and the ground circuit.

    Main line between dlc and abs circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...

    A-BAG branch line circuit
    Diagnosis Procedure 1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow". Is the inspection result normal? YES >> Replace t ...

    Other materials:

    Evaporative emission system
    System Diagram EVAPORATIVE EMISSION LINE DRAWING 1. Intake manifold collector 2. EVAP service port 3. EVAP canister purge volume control solenoid valve A. From next figure 1. EVAP control system pressure sensor 2. EVAP canister vent control valve 3. EVAP canister A. To previous figu ...

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit ...

    CVT fluid
     RE0F09B Inspection CHECKING CVT FLUID Fluid level should be checked with the fluid warmed up to 50 to 80°C (122 to 176°F). The fluid level check procedure is as follows: 1. Check for fluid leakage. 2. With the engine warmed up, drive the vehicle in an urban area. When ambient t ...