Nissan Altima (L32) 2007-2012 Service Manual: ECU diagnosis
BCM (BODY CONTROL MODULE)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
Terminal Layout
Physical Values
1: Sedan only
2: With LH front window anti-pinch
3: With LH and RH front window anti-pinch
Wiring Diagram - TIRE PRESSURE MONITORING SYSTEM - Coupe
Wiring Diagram - TIRE PRESSURE MONITORING SYSTEM - Sedan
Self-Diagnosis (With CONSULT-III)
FUNCTION
Self-Diagnostic Results Mode
NOTE: Before performing the self-diagnosis, be sure to register the ID or else the actual malfunction location may be different from that displayed on CONSULT-III.
Self-Diagnosis (Without CONSULT-III)
SELF DIAGNOSTIC PROCEDURE (WITHOUT CONSULT-III)
1. Turn ignition switch ON.
2. Ground the tire pressure warning check connector to initiate self diagnosis.
3. Compare the flashing pattern with the flash code chart below.
NOTE: The system is normal when the low tire pressure warning lamp flashes 5 times and continues repeating. Selfdiagnosis results are erased automatically by turning the ignition switch “OFF”.
C1734 control unit
Description
An internal malfunction has been detected in the TPMS function of the BCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULTS
1. On SELECT DI ...
Other materials:
Vehicle security indicator
Description
• Vehicle security indicator is built in combination meter.
• NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system
conditions are indicated by
blink or illumination of vehicle security indicator.
Component Function Check
1.CHECK FUNCTION
1. Perform “ ...
AV Branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the AV control unit for damage, bend
and loose connection (unit
side and connector side).
I ...
Seat belt extenders
If, because of body size or driving position, it is
not possible to properly fit the lap/shoulder belt
and fasten it, an extender that is compatible with
the installed seat belts is available that can be
purchased. The extender adds approximately 8 in
(200 mm) of length and may be used for eith ...
