Nissan Altima 2007-2012 Service Manual: Electrical units location

ENGINE COMPARTMENT

PASSENGER COMPARTMENT

LUGGAGE COMPARTMENT

    Ground
    Ground Distribution MAIN HARNESS ENGINE ROOM HARNESS FRONT END MODULE HARNESS ENGINE CONTROL HARNESS BODY HARNESS BODY NO. 2 HARNESS HARNESS Harness Layout HOW TO READ HARNE ...

    Harness connector
    Description HARNESS CONNECTOR (TAB-LOCKING TYPE) • The tab-locking type connectors help prevent accidental looseness or disconnection. • The tab-locking type connectors are disconnected by ...

    Other materials:

    P0850 PNP Switch
    Description When the selector lever position is P or N, park/neutral position (PNP) signal from the TCM is sent to ECM (CVT models). When the selector lever position is Neutral position, park/neutral position (PNP) switch is ON. ECM detects the position because the continuity of the line ( ...

    Floor trim
    Exploded View 1. Spacer (LH) 2. Floor carpet 3. Spacer (RH) 4. Floor mat hook Removal and Installation REMOVAL 1. Remove the diagnosis sensor unit. Refer to SR-17, "Removal and Installation". 2. Remove front seat (RH/LH) and rear seat cushion. Refer to SE-23, "Removal ...

    BSW system operation
    The BSW system operates above approximately 20 MPH (32 km/h). When the camera unit detects vehicles in the detection zone, the Blind spot indicator light located inside the outside mirrors will illuminate. If the turn signal is then activated, the system chimes (twice) and the Blind spot i ...