Nissan Altima Owners Manual: Engine compartment

CAUTION


CAUTION

Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire.

If any electrical equipment does not come on, check for an open fuse.

1. Be sure the ignition switch and the headlight switch are OFF.

2. Open the engine hood.

3. Remove the fuse box cover by pushing the tab and lifting the cover up.

4. Remove the fuse with the fuse puller. The fuse puller is located in the center of the fuse block in the passenger compartment.

5. If the fuse is open A , replace it with a new


5. If the fuse is open A , replace it with a new fuse B .

6. If a new fuse also opens, have the electrical system checked and repaired by a NISSAN dealer.

    Fuses
    Two types of fuses are used. Type A is used in the fuse boxes in the engine compartment. Type B is used in the passenger compartment fuse box. Type A fuses are provided as spare fuses. They a ...

    Passenger compartment
    Fusible links If the electrical equipment does not operate and fuses are in good condition, check the fusible links. If any of these fusible links are melted, replace with only Genuine NISSAN pa ...

    Other materials:

    Combination meter
    Diagnosis Procedure 1.CHECK FUSES Check for blown combination meter fuses. Is the inspection result normal? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. 2.POWER SUPPLY CIRCUIT CHECK 1. Disconnect combination meter ...

    Front grille
    Removal and Installation 1. Front bumper fascia 2. Front grille 3. License plate bracket 4. Fog lamp finisher (if equipped) 5. Fog lamp (if equipped) A. Clip C101 Removal 1. Remove the front fender protectors RH and LH. Refer to EXT-19, "Removal and Installation". 2. Remove ...

    P0460 fuel level sensor
    Description The fuel level sensor is mounted in the fuel level sensor unit. The sensor detects a fuel level in the fuel tank and transmits a signal to the combination meter. The combination meter sends the fuel level sensor signal to the ECM through CAN communication line. It consists o ...