Nissan Altima Owners Manual: Engine coolant temperature gauge

The gauge indicates the engine coolant temperature.


The gauge indicates the engine coolant temperature.

The engine coolant temperature is within the normal range 1 when the gauge needle points within the zone shown in the illustration.

The engine coolant temperature varies with the outside air temperature and driving conditions.

CAUTION

If the gauge indicates coolant temperature near the hot (H) end of the normal range, reduce vehicle speed to decrease temperature. If the gauge is over the normal range, stop the vehicle as soon as safely possible. If the engine is overheated, continued operation of the vehicle may seriously damage the engine. See “If your vehicle overheats” in the “In case of emergency” section for immediate action required.

    Tachometer
    The tachometer indicates engine speed in revolutions per minute (rpm). Do not rev engine into the red zone 1 . CAUTION When engine speed approaches the red zone, shift to a higher gear or reduc ...

    Fuel gauge
    The gauge indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. The gauge needle returns to 0 (Empty ...

    Other materials:

    Audio antenna (coupe)
    Location of Antenna 1. In-line connectors M87, M501 2. Audio unit harness 3. Audio unit 4. Satellite antenna 5. Audio antenna feeder 6. Satellite radio antenna feeder 7. Window Antenna 8. Antenna amp. 9. Satellite radio tuner Window Antenna Repair ELEMENT CHECK 1. Attach probe circuit ...

    P0603 ECM Power supply
    Description Battery voltage is supplied to the ECM even when the ignition switch is turned OFF for the ECM memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the idle air volume learning value memory, etc. DTC Logic DTC DETECTION LOGIC DTC CONFIRMAT ...

    P0300, P0301, P0302, P0303, P0304 Misfire
    DTC Logic DTC DETECTION LOGIC When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the crankshaft position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is occurring. The misfire detection logic consists of the following ...