Nissan Altima 2007-2012 Service Manual: Floor trim

Exploded View

1. Spacer (RH)

2. Spacer (LH)

3. Floor mat hook

4. Floor carpet

5. Harness clamp

Removal and Installation

REMOVAL

1. Remove front seat (RH/LH) and rear seat cushion. Refer to SE-51, "Removal and Installation" and SE-53, "Removal and Installation".

2. Remove lower body side trim. Refer to INT-36, "Removal and Installation".

3. Remove center console. Refer to IP-12, "Removal and Installation".

4. Remove the connector duct (RH/LH) (2) and the center connector duct (1) from heater and cooling unit. Refer to VTL-23, "DUCTS, NOZZLES AND GRILLES : Components".

5. Remove the bracket bolt, then position the parking brake cable aside.

6. Disconnect the drain hose (4) from the heater and cooling unit, then set aside.

7. Remove the three bolts (A) and one nut, then remove the bracket (3).

8. Remove the diagnosis sensor unit. Refer to PWO-5, "Removal and Installation".

9. Remove the parking brake cable nuts (A), then position the parking brake cables (2) aside.

10. Remove the bracket nuts (B), then remove extension bracket (1) and center console rear bracket (3).

11. Remove front seat belt floor anchor bolt (RH/LH). Refer to SB-8, "Removal and Installation".

12. Release the tab, then remove floor mat hook.

13. Release the tabs and open harness clamps (seven-R/H and seven-L/H). Position harness and floor carpet cut-out areas outside of harness clamps.

14. Fold corners toward center, then remove floor carpet.

INSTALLATION

Installation is in the reverse order of removal.

    Rear parcel shelf finisher
    Exploded View 1. Seatback release escutcheon 2. Seatback release cover 3. Child anchor cover 4. Seatback latch cover 5. Rear parcel shelf finisher 6. High mounted stop lamp (if equipped) A. ...

    Headlining
    Exploded View 1. Room/Map lamp assembly 2. Mirror harness cover 3. Sunvisor holder 4. Sunvisor 5. Sunvisor cover 6. Headlining assembly (without sunroof) 7. Headlining assembly (with sunroo ...

    Other materials:

    Folding rear seat
    Interior trunk access The trunk can be accessed from the driver side (if so equipped) and passenger side of the rear seat for loading and unloading, as shown. 1. Move the front passenger seat to the most forward position. 2. Open the access cover on the rear parcel shelf. 3. Push down on the ...

    On-vehicle repair
    WHEEL HUB Removal and Installation 1. Knuckle 2. Baffle plate 3. Wheel hub assembly 4. Brake rotor 5. Wheel nut 6. Anchor block 7. ABS sensor 8. Parking brake cable A. Refer to PB-6, "PEDAL TYPE : Exploded View" (Pedal type), PB-7, "LEVER TYPE : Exploded View" (Leve ...

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...